Ceramic Coating Jacksonville, FL

Ceramic coating is the superior replacement for car wax. Once we apply the coating to your car, you won’t have to add wax to for years! If you’re looking for a nano-ceramic coating installer in Jacksonville, your search ends now.

What is a ceramic coating?

A Ceramic Coating (such as Opti-Coat Pro, C.Quartz, and Ceramic Pro) is a liquid polymer that is applied by hand to the exterior of a vehicle. The coating chemically bonds with the vehicle’s factory paint, creating a layer of protection. Ceramic car coatings have revolutionized paint protection through the use of nano-technology that is miles ahead of even the best wax products.

Benefits of ceramic coating for cars

Our professional-grade ceramic coatings keep your car cleaner much longer, increase the lifespan of your paint, & add an unreal gloss.

Paint correction

A paint correction is part of the ceramic coating process. Before we apply the coating we must remove any defect from the surface to make sure we don’t seal them underneath the coating making them extremely difficult to remove later on. Common paint defects are:

Ceramic Coating Packages


$ 529 M $629 / L $729 / XL $829
  • Hand Wash
  • Clay Bar Treatment
  • Machine Polish
  • Ceramic Pro Sport
  • Duration = 8 hours


$ 799 M $899 / L $999 / XL $1,099
  • Hand Wash
  • Clay Bar Treatment
  • Machine Polish
  • Crystal Serum Light
  • Duration = 8 hours


$ 999 M $1,099 / L $1,199 / XL $1,299
  • Hand Wash
  • Clay Bar Treatment
  • Machine Polish
  • Crystal Serum Light + EXO
  • Duration = 8 hours



Need Help?


Your ceramic coating questions answered.

What is Ceramic Coating? Industry-grade ceramic coating is a chemical polymer solution that is applied to the exterior of a vehicle to protect it from external paint damage. Typically applied by hand, it blends with the paint of your car and creates an additional hydrophobic layer of protection.

Installing a ceramic coating is an extremely tedious process. Below is a breakdown of how ceramic coatings are installed.

100% Hand Car Wash
Using PH neutral soap and a clean wash mitt and safe towel to dry.
Paint Decontamination
Clay bar treatment to mechanically decontaminate the paint followed by a chemical decontamination with iron removers.
Labor intensive Machine Paint Correction
We must make your car’s paint as close to perfect as possible so that we don’t seal those defects under the coating.
Surface Cleansing Coating Prep
We apply an alcohol-based cleansing solution to give the coating a proper surface to bond too. Unlike wax coatings bond to your clear coat.
Tedious Panel by Panel Installation
We apply the coating panel-by-panel with an applicator and special soft towels to prevent further damage.

Ceramic coatings last anywhere from 6 months to 7+ years depending on the formula.

The cost of a ceramic coating ranges from $300 – $3000 depending on two factors. How much paint correction is required & how much durability is desired.

Removing a ceramic coating requires labor intensive cutting and polishing with a machine polisher, pads, and abrasive compounds. You must be very careful to not go past the clearcoat.

A ceramic coating bonds to your clear coat and a wax does not. A wax also diminishes with heat and chemicals ceramic coatings are chemically and UV resistant.

The installation of a ceramic coating can take anywhere from 6-15 hours depending on the condition of your vehicles paint since most of the time is spent in paint correction pre-install.

The best way to maintain a ceramic coating is to hand wash your vehicle using a PH balanced soap diluted properly. You should consider drying the vehicle with a blower or extremely soft towel with little pressure.

Improved formulation to increase the resistance of water spotting on coated vehicles

Water contact angle that surpasses 110° and retaining close to this angle for a long periodDEEP GLOSS
Unmatched gloss that lasts years.

Surface stays clean for a longer period thanks to the anti-fouling effect